Ballast Products & LED Interconnections

New Ballast Products & LED Interconnections from Tyco Electronics

LIGHT-N-LOK Connectors A new connector for fluorescent ballast lighting applications provides a hot-pluggable disconnect to allow safe field servicing without exposing personnel to electrical shock hazards. Available in 2 or 3 position pre assembled mated connector sets or with factory installed flying leads. The connector accepts 18 AWG solid wire.

A97617-ND (2 Position) A97691-ND (3 Position)

Features  • Available in 2 and 3 Position Sizes  • Poke-In Termination for 18 AWG Solid Wire for Easy Tool-Less,    Field or Factory Installation  • Integral Strain Relief Prevents Inadvertent Wire Twist Out and Pull Out  • Designed for Hot Plugging  • Snag Resistant Rounded Housings  • Compact Connector Housings: 2 position Assembly Fits Through a    5/8” Diameter Knock-Out Opening; 3 Position Assembly Fits    Through a 7/8” Diameter Knock-Out Opening  • Connector Latches Prevent Unintentional Disconnect of Connector  • Standard 3/8” Wire Strip Length  • Can be Supplied as Pre-Assembled Mated Connector Sets with or    without Factory Installed Flying Leads  • Product is Marked (English/French) in Support of CSA Luminaire    Labeling Requirements Applications  • Commercial Ballast Lighting System

Surface Mount Technology (SMT) Poke-In Connectors This 2-position, low profile SMT wire poke-in connector is designed for LED lighting applications. Available in surface mount tape and reel packaging, the connector is designed to accept a wide range of wire sizes and types.

A97618TR-ND

Features  • Tape & Reel Packaging for High Speed SMT Processes  • RoHS Compliant Redundant SMT Pads Prevents Peeling  • Rounded Corners to Minimize Shadowing  • Side to Side Stackable with Pads on 4mm Centers  • Accepts 18, 20, 22 AWG Solid Wire; 18, 20 AWG Prebond Stranded;    18 AWG Stranded  • Cost Effective Alternative to Hand Soldering Wires  • Low Profile Design  • Flat Top Surface Allows for Vacuum Pick Up  • High Temperature Material for Reflow Processing Applications  • Lighting Controls  • Interconnecting Strings of Printed Circuit LED Light Modules

IDC Poke-In Wire Tap/Splice IDC Poke-In Wire Tap/Splice combination design accommodates quick termination of power wiring (tap) out to individual light fixtures (splice). The two-piece, dove tail housing alignment design ensures IDC termination. The tap wire retention force exceeds 10 pounds.
A97619-ND (Brown) A97620-ND (Blue)	Features  • Tap Termination Allows Feed-Through in 12 AWG (Solid or Stranded)    or 18 AWG THHN/THWN Wire  • Splice Poke-In Accommodates Two (2) Pre-Stripped 18 AWG Solid    Wires  • Cost Effective Termination System for Installation of Ballast Lighting    Systems Applications  • Commercial Ballast Lighting System